Test FWC Anti Freeze if needed, add Coolant to System
Lower Unit
Change Gear Lube
Remove Prop, Grease Spline, Check Condition
Check Water Pump Output
Remove Drive, Grease U-Joints, Gimble Bearing
Check Engine Alignment M/C, OMC/Cobra, & Volvo
Check Anodes, Replace As Needed
Fuel System
Treat Fuel w/Conditioner
Adjust Carb. If Needed
Check Condition of Fuel System
Inspect Fuel Lines
Replace Fuel Filter
Electrical System
Test Battery, Charge if needed
Check Water level
Check Charging System Output
Check Battery Connection & Clean if needed
Boat
Check All Accessories, Instruments & Lights
Check Steering Cable Operation & Grease
Remove Drain Plug and Tape to Steering Wheel
Trailer
Grease Wheel bearings
Check Lights
Check Winch & Lube
Check Tongue Jack & Grease
JET BOAT & WAVERUNNER WINTERIZATION SPECIALS
4 STROKE YAMAHA WATERCRAFT WINTERIZATION:
Change oil & filter, add fuel stabilizer, inspect motor mounts, adjust cables, set idle speed, grease all zirks, inspect pump and impeller, inspect air cleaner, battery serviced & disconnected, test compression, replace spark plugs if needed additional charge, synch throttle bodies.
2 STROKE YAMAHA WATERCRAFT WINTERIZATION:
Inspect motor mounts, compression test, replace spark plus, inspect power valve operation, adjust oil pump, drain water trap, inspect fuel filter, stabilize fuel, fog engine, grease started drive, grease thru hull bearing carrier, adjust all cables, inspect pump & impeller, service & disconnect battery.
If power valves need cleaning that is an additional charge.
2 STROKE SEADOO WATERCRAFT WINTERIZATION:
Compression test, inspect valves, clean fuel filter & water pump, change pump oil, inspect pump & impeller, adjust all cables, set idle speed, stabilize fuel, fog motor, grease PTO Coupler, inspect motor mounts, service and disconnect battery, replace spark plugs.
YAMAHA JET BOATS:
SINGLE ENGINE: Change oil & filter, add fuel stabilizer, inspect motor mounts, adjust cables, set idle speed, grease all zirks, inspect pump and impeller, inspect air cleaner, battery serviced & disconnected, test compression, replace spark plugs if needed additional charge, synch throttle bodies.
TWIN ENGINE: Change oil & filter’s, add fuel stabilizer, inspect motor mounts, adjust cables, set idle speed, grease all zirks, inspect pump’s and impeller’s, inspect air cleaner’s, battery serviced & disconnected, test compression, replace spark plugs if needed additional charge, synch throttle bodies.